579 Steam results · Checked
Cl2+H2O. Solo and Quad variants.
Uses the magnesium reaction with carbon dioxide to seperate carbon and oxygen. Very stable. To get it started, insert some carbon dioxide just above the bubblers Oxygen comes out the top, carbon falls through the carbon dioxide. It was done that way to not
Input Borax, output Boron, Sodium, and Oxygen. Fairly stable, may have to watch for broken heaters in the bottom right and the 2-1 splitter malfunctioning with the electrolyzer in the bottom left.
Takes Yttium Oxide and produces Yttrium and Hypochlorous Acid. Design works for any of the X-oxide recipies that use Calcium to extract the raw element, such as Dy, Gd, Y, Sc, U, by chaning a couple filters Note Currently broken due to Quick Lime requiring
Used the Lepidolite + H2SO4 reaction to create several outputs, including HF Acid
Converts Plutonium to Moscovium-289 for the last 3 isotopes. All latch outputs should be off before adding any Plutonium. The buttons in the output tubes of each module can be used for this if they dont reset properly
Turns Plutonium into any isotope that follows and Alpha, Proton, Decay, Neutron chain.
Put in Iron or Mn WO4, get out FeO or MnO and Tungsten. There's also hydrogen and oxygen gas. Its slow but it works. Youll have to change two filters to work with MnO. Reclaims materials. You'll have to watch where the water ends up, especially where it mi
Turn on using bottom switch. Feed carbon dioxide at the bottom left. Output Carbon and Oxygen on the right side. May need to reroute recirculating carbon dioxide in case of clogging.