Converts borax to boron using a magnesium recycler. Filter Setup: - Reference image 2. - Note the filters at the bottom of tank 7 alternate between magnesium oxide and boron. Machine Breakdown (Reference image 3): Inputs: - Borax (Tank 2) - Hydrochloric Ac
578 Steam results · Checked
Special thanks to alistor∴ on discord for the electrolyzer design! Filter configurations are as follows (From Top to Bottom, Left to Right, or just consult image 2). - Match Filter (2 Width x 1 Height ) : Hydrogen Gas - Match Filter (1Wx1H) : Hydrogen Gas
Input just enough chlorine gas and magnesium. Then fill up the carbon and zirconium Orthosilicate chambers. have some power if you want the recycling of magnesium and chlorine. Be sure not to overfill the Mg and Cl2 chambers. REFER TO NUMBERS IN IMAGE FOR
Input: Ilmenite, Carbon, Chlorine (in middle chamber), and magnesium. Ouput: Rust, Titanium, and Magnesium Chloride. REFER TO NUMBERS IN IMAGE FOR FILTER SETTINGS: 1. Iron Titanite (FeTiO3) 2. Rust (Fe2O3) 3. Titanium Dioxide (TiO2) 4. Carbon (C) 5. Carbon
This design got me through 1/3 of the game by itself! Burn wood or coal below the mixer. Works with almost every combination of solid and liquid ingredients. Tested thoroughly to always catch all byproduct gasses and liquids. Note: This forge is designed t
1. Add Seawater here 2. Lye collects here, a little of NaCL too 3. Hydrogen Gas collects here 4. Chlorine Gas collects here 5. HCL collects here Steam vents on lower right side Delete the numbers after your comfortable as it can cause a few issues Filter s
1. Add dirt to the dirt container 2. Plant the nuts 3. Add steel to the steel container 4. Enjoy free wood
参考:Ceramic Factory v1.1 @Rodger 尽量使用了更少的材料. 框架使用石灰岩。 使用说明: - 左侧加满石灰岩砾石或磷灰石砾石 - 右侧加入适量的水 - 加热模块温度调到最高! - 漏斗口过滤设置:黏土(注意不是黏土墙!) - 加热部分末端过滤设置:陶瓷
-Top 1 non-match filter set to some unobtainable pixel like Seawater Source -Bottom 3 non-match filters set to Hydrochloric Acid -Heat maximum setting There is a single Hydrogen gas pixel as trigger in blueprint, it should work after setting the non-match
This reactor consist in three main parts. At the top you have the load area, with the posibility to add the correct quantity of reactants. The second part its the main body, whit mixers and heaters elements and filters for products and subproducts and the
To cook small. Works perfectly with gasoline, querosene, etc. Works good with propane. Works ok with methane. Works terrible with ethanol. Optimized Version