
259 Parts per wheel You can change the settings, just make sure to change the 3x11 wheel's They have some slight collision issues with the ground but only while turning hard at high speed, only way to stop this would be to make them appear to float above t
9,873 Steam results · Checked
Tried my best to recreate the suspension of the real car. The lever dampers don't work very well so they're just there for accuracy. The actual dampening is done by the leaf springs which is a bit weird. The engine is roughly the same as the real one. Its
Animated 13 Parts Default Keybinds Left Paddle - Ctrl Right Paddle - Shift
H - Starter G - Throttle !!! causes fps drops on low end pc !!!
1970's model International Loadstar F-1800 -10 speed manual dual range transmission -Parking brakes must be released for both truck and trailer right ALT and right CTRL respectively and will reapply upon exiting the vehicle automatically -Uses arrow keys t
A high reving high performance flatplane V8 motor that produces around 630HP at 9000rpm This is suited for high end racing and short gearings. When inserting in to a build delete the pin and pink block. Also set all throttlebodies as you wish. If you happe
5.2L V10 Trophy truck -Gallardo LP560 V10 5.2L Engine from SasM8 -Compact 5 Speed Sequential Gearbox From Potatohedron -Performance Steering Wheel from SasM8 -Double Wishbone front Suspension -4 Link Trailing Arm Suspension in the rear Controls: Engine Sta
I just snagged this mod off the workshop and added a v-twin with a turbo and kickstarter which can be finicky, just time the kicks and get the engine cranking at idle rpm and it'll turn on. I also adjusted the suspension and added rear steer. And Parking B
Thanks for the engine and the wheel SasM8.