Yesterday's Day-Two Update ended with a list called "Coming next". Three of its four items are in this build, along with a second round of things you asked for on Discord, in reviews and by email.
What we promised yesterday
- Copy and paste between contracts. Copy on one bench, open another contract and paste. Only the parts the new bench offers are put down.
- A RAM test that looks at every address line. The table now writes single addresses and reads them back, so a wrong address order is caught on the bench and not at the factory.
- A factory test that says what failed. The message names the inputs. The failing case also appears under the truth table, and you can step through it on your own circuit.
- Names for the pins of your own chips. Type them in the cast dialog.
The search box on the shelf is not in this build. It is still on the list.
Faster building
- Click to place. Click a part on the shelf and it stays in your hand. Every click on the bench places another one. Dragging works as before.
- A wire from a wire. Drag from a wire that is already there to start a new one from the same source.
- A colour for selection. A selected part is outlined in cream. Turquoise now means one thing only, a signal that is on.
- Information cards close when you click outside them.
- Type the value of a bus INPUT on its card. Alt+click steps it back.
Your own chips, continued
- Look inside without leaving. Select a chip on the bench to see its NAND count and critical path, and open See inside from there. You can go down into the chips inside it too.
- Update a chip. Cast again under the name of one of your chips and the game offers to update it. Every draft that uses the chip follows. A chip used in delivered work is left alone, and so is one whose pins no longer match.
- Rename a chip from its card on the bench.
- The part card compares your critical path with the reference, next to the area.
- Past act one, a part that reaches the reference earns a quiet tick on the desk.
Stricter tests
Some of you found builds that passed the table and should not have. Thank you for showing us.
- REG1 and REG4 now catch a clock gated by the write input.
- COUNT4, ACC4, the calculator, the fetch and the program counter check what happens when the enable changes while the clock is high.
- PHASE checks mem and halt changing in the middle of an instruction.
A heads-up. If you delivered a REG1 that gates the clock, ACC4 and the calculator built on it will fail their tests until you rebuild REG1. Contracts you already delivered stay delivered.
Clearer reference material
- The NIB-4 card is open on the hardware contracts of act three, with the layout of the instruction word.
- On the CORE, WORKER and WARP tables, click a row to read the program it runs.
- The clock edge lesson now says what d was when the clock rose.
Your save is safer
If the game cannot read your save at startup, it keeps a copy beside it before starting a new one.
Known issue
On the card of a selected chip, a click on the middle of the See inside button can close the card instead of opening the chip. Click near the edge of the button, or double-click the chip on the bench. A fix is on its way.
Coming next
- A search box on the parts shelf, with NAND count and delay on the tiles.
- Moving wires by hand. It is the request we hear most, and it touches the save file, so we will take the time to get it right.
- A live view of the signals inside a chip.
Thank you
If something breaks, the fastest way to help is the game.log from the game's log folder, posted in the Steam discussions or on Discord. If you wrote a review while these problems were there, we would be grateful if you gave the game another look.
