This update is mostly about the race weekend behaving the way a race weekend should. Every team now runs a finite allocation of tyres through practice, qualifying and the race, and has to decide when to use new rubber and when to save it. Qualifying no longer decides itself in Q1, positions are fought for from segment to segment, and you can go back to any session's results at any point in the weekend. AI engineers now read the track before sending a car out, and react when the weather changes. Team HQ has a new supplier record, the Drivers and Car sections now open inside the main screen, and you can go back to the start of any of your last five race weekends. Your existing careers load and continue.
Tyres: a real allocation for every team
- Every team, yours and every rival's, now runs its weekend tyre allocation in every session. Before, every run out of the garage and every pit stop fitted a brand-new set for free, so the allocation only meant anything when a session was simulated.
- Any set, new or used, can go on a car in practice, qualifying or the race. A punctured set, or one worn below 12% of its life, is out of the allocation for the rest of the weekend.
- A new TYRE SET call on the weekend screen decides what your cars start each session on: NEW SET, USED SET, or ENGINEER (used sets in practice, new ones for qualifying and the race). Running practice on used rubber is how you keep a new set back for the lap that counts.
- In practice a car stays on its set from run to run. It only changes when you switch compound or the set is punctured or worn out. A set that comes off keeps its laps and wear, and goes back on that way.
- In qualifying with NEW SET or ENGINEER chosen, each run takes a fresh set, as a real team would. Race stops take a different set from the allocation.
- If a compound runs out, the car takes the best remaining set for the same conditions, a medium in place of a soft, say.
- AI teams run the Balanced allocation and make the ENGINEER call.
- Tyre lists now read NEW, USED, FITTED or WORN OUT, based on whether a set has actually turned a wheel.
- Fixed: at the start of every practice and qualifying session, the set a car was sitting on in the garage was logged as used as soon as it went out, although it had not done a lap.
Qualifying
- Fixed: simulated qualifying showed the same table three times. Q1, Q2 and Q3 all showed the final grid, each car on the lap that decided its final place. So the five cars sitting P11 to P15 after Q1 were always the five knocked out in Q2. Each segment now shows only the cars that ran it, ordered by that segment's own lap times. The race step still shows the full grid.
- Fixed: positions were never fought for. Once the table showed each segment's own laps, it was clear that the order hardly moved from Q1 to Q2 to Q3: in testing, the top eight came out in exactly the same order in consecutive segments 80% of the time. Each simulated car's lap was its rated pace plus a wobble of under a tenth, and the best of three attempts smoothed even that away, while neighbouring cars were two or three tenths apart. Now every car has its own form in each segment (how well car and driver come together on that run), laps vary from attempt to attempt, a lap can be spoiled by a lock-up, a moment or traffic (a little more often for less consistent drivers), and the track gets quicker as it rubbers in. Q3 has two attempts instead of three. The top eight now keep the same order between segments almost never, while the quickest cars still usually end up at the front.
- Simulated practice sessions no longer come out in the same order every time. Each car now runs its own programme in each session, with different fuel loads and a different amount of push, and about one in four never does a low-fuel run, so its best time understates its real pace, as practice times do.
- AI teams react when the track changes. Each AI car used to get one run per qualifying segment, so a car whose run fell in the rain set its time on intermediates and sat out the rest of the segment once the track dried. In testing, fifteen of twenty cars finished a drying Q1 on inters. A car parked on the wrong tyres now goes back out, as long as there is time for a flying lap. The same applies in practice, and in the other direction when rain arrives.
Check any session's results during the weekend
- Every practice and qualifying result now stays available for the rest of the weekend. Before, the weekend screen only showed the session you had just run. Click any completed session in the timeline at the top, or press LEFT and RIGHT, to bring its table back. On race day the RACE card shows the starting grid.
- Result tables now show each car's gap to the fastest lap.
- Results are kept in your save, so they are still there if you quit and come back mid-weekend. A weekend already in progress when you update keeps results from its next session on.
- A live qualifying session now records each car's lap in Q1, Q2 and Q3, so each segment can be looked at on its own times, as a simulated one already could.
AI engineers pick their moment
- In practice and qualifying, an AI car due out of the garage no longer simply leaves on schedule. Its engineer reads the circuit first. A car on a flying lap about to pass the pit exit, or a slow car just ahead that it would catch on its own flying lap, is a reason to wait for a gap.
- How much traffic an engineer can see, and how long they will hold the car, depends on the engineer. The best in the paddock read a long way and will wait up to about 30 seconds. An average engineer only spots traffic close to the exit, and a weak one sends the car out on schedule and hopes.
- No car is ever held so long that it could not complete an out-lap and a flying lap before the flag.
- Measured on the same sessions with and without this: fewer cars meet traffic, traffic costs your own flying laps less time (0.69 s a lap against 0.81 s), and the field gets out of your way at least as often as before.
The 3D view
- Rain spray hangs in the air where the cars have been. It used to be drawn fresh every frame as a fixed trail hanging off the back of each car, so it looked like a smoke trail and swung round with the car through corners. It is now thrown off the rear tyres as mist that stays where it was released, rises, spreads and fades within about a second, and follows the line the car drove. How much comes off still depends on the water under each car and how fast it is going.
- Fixed: cars shook in their garage boxes. A car that had just parked was being redrawn between its box and its last position in the pit lane, many times a second, for as long as it sat there.
- Pressing 1 or 2 now moves the camera to that car, as clicking the car's card already did. Before, it only chose which car the pit controls acted on.
Readouts that mean what they say
- Fixed: a fresh power unit on a smaller team read as failing. Several screens (PARTS & DAMAGE, the summary tile, the pit wall and CAR STATUS) coloured engine health from the car's reliability rating, which on a healthy car ranges from 0.38 to 0.95 depending only on the team. So a brand-new engine on a weaker team could show red from the first lap, and much of the grid showed amber on fresh parts. Engine health is now measured against each car's own healthy baseline, so a fresh engine reads close to 100% on any team.
- The 3D engine fire is judged the same way, so how close to failure an engine has to be before it catches fire no longer depends on which team built it.
- Fast-forwarding a long session no longer makes the window feel frozen. Skipping to the end of a practice session or a race ran the simulation in fixed chunks sized from an estimate that turned out to be 27 times too optimistic, so the progress screen updated less than twice a second and CANCEL could take half a second to respond. The work is now paced by time, so the window stays responsive on any machine. The fast-forward itself is no quicker; the same simulation runs either way.
Team HQ
- Supplier records. A new SUPPLIER RECORD tab under Suppliers shows every manufacturer's advertised specification beside what it has actually delivered: finish rate, its own failure rate, points per race, wins, podiums and best finish, season by season, with the teams that ran it. Results follow the supplier a team was actually running at the time, so a team that switches does not take its history with it. Records begin with this update; earlier seasons show as no data rather than guesses.
- The Drivers and Car sections now open inside the main screen. Market, Contracts, Academy, Staff and Window, and Setup, Testing, Designs, Livery, Parts and Driver Aids, sit under a tab row inside Team HQ with the navigation still visible, the same way History & Results works, instead of each opening as a separate full-screen page.
- Contracts no longer lists free agents. Signing someone new is done in the Market.
Saves and support
- Go back further than last week. The game now keeps a save from the start of each of your last five race weekends. LOAD EARLIER SAVE on the main menu (it replaces Restore Last Week) lists them newest first, for example "Start of Round 7 · Valserra" with the season and when it was saved, and asks you to confirm, because going back replaces your current progress.
- If the game crashes, it now leaves a crash report behind, with a note of what you were doing at the time. Settings has a link that opens the folder, so you can find the report and send it to us. Nothing is sent anywhere automatically, and the crash window only offers to close.
- URS1 now keeps the twenty most recent session diagnostic reports and removes older ones. Until now they were never deleted, at a few hundred KB per session. Race replays have been capped at twenty since 0.9.3.
Known issues
- The safety car itself, at the head of the train, still runs about 6% slower than the printed multiplier, although the field as a whole lands on it. Known and not yet fixed.
Under the hood
- The automated suite is now 261 tests, up from 246 at 0.9.3.
- Careers from 0.9.3 load, autosave and continue. The save format has only gained new fields.
- If you update partway through a race weekend, the AI teams' tyre allocations are rebuilt from the sessions they have already run, so nobody gets a free set of new tyres for the rest of the weekend.
Thank you to everyone testing and sending feedback.
