This is a stability and correctness pass focused on cabling, power, and rack hardware.
Fixes
- Cables no longer vanish on their own. Correctly-laid network cables could randomly disappear with no incident or warning. That behaviour has been disabled — a cable now stays put until you unplug it.
- Negative balances now read red. When your cash goes negative, the figure is shown in red instead of green.
- Power draw now displays on the ops console network map. The network map's power view was stuck at 0 W for every device; it now shows each device's power draw.
- Dual-PSU devices accept both power cords. Gateways and appliances with two power supplies would only take a single AC cord. Both inlets can now be plugged.
- Vertical PSUs cable up correctly. On 2U devices where the power supply is mounted vertically, the AC plug and cord now seat in the correct orientation.
- Corrected rack heights for several switches and gateways. A number of switches and gateways reserved too many rack units versus their actual chassis. They now occupy the correct height, so they sit flush in the rack.
Improvements
- Network map overlays are now mutually exclusive. Wear, Power, Opex, and Security are single-choice - selecting one automatically turns off the others, so you always see a clean, unambiguous view. (Hosts, Racks, and LACP remain independent toggles.)
Notes
- Existing save files are automatically repaired on load — corrected hardware sizing and power-supply counts apply to gear you've already placed.