In response to your important feedback on a variety of add-ons available for Train Simulator 2017, we have today released a patch for LNWR G2 Super D.
Changelist
New Liveries
- LMS Crimson Lake (Pre-1928)
- LMS (Pre-1928)
New Features
- Trimmer assist
- Priming notifications
- High/Low water level notifications
- Injector assist
- Match lights to assist in seeing vacuum/pressure gauges temporarily at night.
Improvements/fixes
- Manual improvements
- Fixed some sounds incorrectly set up as stereo format
- Fixed fading distance for some sounds
- Improved several sounds with new samples
- Delayed activation added to steam sander
- Fixed bug causing air deflector to appear on ai locomotives
- Added particle effects for priming
- Added particle effects for ejector failure
- Added additional liveries to “G2A” numbers.
- Improved adhesion model slightly so the locomotive wheels should spiral out of control during a slip as much.
- Minor improvements to a select few particle emitters to hopefully increase performance slightly
- Some script optimisation to hopefully increase performance a little
- Optimisation of the steam chest simulation so it should now be much more steady under low fps conditions.
- Stopped engine blowing back in tunnels
- Stopped Wakefield lubricator drips appearing on non-Wakefield fitted engines
- Altered Shaders to hopefully stop valve gear appearing through firebox when non-dynamic lighting is used.
- Fixed left hand piston valve animation
- Fixed an anachronism on the rear tender steps on engines without tender cabs.
- Altered key to isolate ejector to hopefully prevent accidentally isolating the injector.
This patch will be approximately 290MB.
If you own the LNWR G2 Super D, the update will download automatically from Steam. If you have any problems/queries with regard to the update, leave a comment below or submit a ticket to our support site where our Support Team will be ready to assist.