Hello Everyone!
We are pleased to say that the first update for Field of Glory II is now available and many thanks yo all of you for your feedback, suggestions and reports of issues.
This update corrects a number of bugs that have been reported such as those in campaigns, with general generation and AI aggression (plus of course various others – the full change list is below)
v1.0.1 is compatible with save games from v1.0.0
If you are playing a multiplayer game then both you and your opponent will need to update your versions.
V 1.0.1 Change List
- Corrected bug that could prevent some units of a “rear echelon” campaign army from arriving on the battlefield.
- Corrected bug that could prevent generals from being deployed in a campaign battle if reinforcement points were insufficient to bring the army’s units up to full strength.
- Corrected bug that displayed incorrect refit cost for army in pursue/don’t pursue campaign choice situations.
- Corrected bug that could cause game to crash if player accepted the confirm dialogue when he still had enough points to buy further units in Force Selection.
- Corrected bug that resulted in generals not being assigned to the non-PotLuck player’s army in MP challenges with specific army vs Pot Luck opponent or Pot Luck army vs specific opponent. Note also that in such challenges, the non-PotLuck army does not get to select his units – this is working as intended, it would not be fair for one player to be able to choose his units and the other not.
- Corrected bug that made disadvantaged AI units even less likely to charge than intended.
- Corrected bug that made it impossible to resend an MP turn if the Server failed to respond.
- Corrected bugs that allowed units that went Fragged in their side’s own turn to make turns and fall backs at half the normal AP cost.
- Various other minor bug fixes.
Editor Clarification:
Water can be “painted” on to a map by using the Base Water tile with Auto-Edging turned On. (If auto-edging is turned Off you won’t be able to see where the tiles have been painted, because the base Water tile uses one of the Open Ground textures to avoid blending issues at the edge of the water. The actual water is applied using overlay tiles – automatically if Auto-Edging in On).